SewingLab

Milano

SewingLab

Milano

Asymmetric draped dress

Pattern characteristics: asymmetric construction, built-in collar, dart manipulation into gathers, adding extra volume for gathers and built-in flounce.

Style analysis: Gown with asymmetric neckline, cap sleeves, gathers from left shoulder to bust level. The waist section is plain and fitted, and there's an asymmetric V separating bodice from skirt. The skirt is divided into two panels that are gathered and create a flowy flounce, ending in side front slit. Back is plain.

Fabric: I suggest creating this dress with a knit, to be able to keep the middle section fitted while removing dart. Silk jersey would be a luxurius choice but cotton or viscose jersey would look great too, or you can go for microfiber or lycra.

Step 1

Start by drawing the dress block with darts and zero to negative wearing ease depending on the fit you prefer and the fabric you’re using.
A full explanation on negative ease patterns is included in our basic blocks course/module 2.

On front and back:

  • raise 2cm from shoulder point (light blue arrow) and redraw shoulder line (red line)
  • lengthen new shoulder line by 6 to 8cm (purple arrow), then drop 2cm (green arrow) and draw the outer part of shoulder line slightly rounded, merging it to new shoulder line (red line)
  • drop armpits by 1 to 1,5cm and redraw armholes – it’s ok if they are a few cm outwards than original ones, if you notice in the image they extend a bit over the arm
  • erase back waist dart and discard half of it from center (blending to zero at hip and shoulder blade levels) and half from side seam
  • erase front waist dart and discard half of it from side seam as done on back
  • adjust length to ground
  • take in 2 to 3cm at knee level or 10cm above it for a light mermaid shape, blending to zero at hips and hemline. Take in also 2cm from center back.

Cut through the new lines or highlight them.

Step 2

Trace a copy of back and create the asymmetric neckline:

  • on left back, widen neckline by 2cm along shoulder line and connect this point to nape point with a straight line (green). Draw a perpendicular 2cm long from the new high shoulder point (green). Draw a slanted line (purple) from this point to nape point
  • on right back, widen neckline by 4 to 5cm and redraw it to nape point.
Step 3

Cut through the new lines and your new back is ready, mark grainline as perpendicular to waist line.

You need a FREE MEMBERSHIP to access next steps.

Join a vibrant community of thousand of sewers!

Do you already have an account? Login or Recover your password now

Free

€ 0 / Per month
  • Can candidate photos for pattern tutorials
  • Access 120+ free pattern tutorials
  • Access 2 NEW tutorials/month